제품소개
Mold Pre-Heating & Descaler
Effectively remove scale and rust inside of the cooling water Line for the maximum cooling efficiency and
prevent stemming inside the refrigerant line. Preheating allows the reduction of working hours for the production of high quality.
Feature
- Removing calcium and magnesium scale from the subterranean water and industrial water (increase cooling efficiency and thermal efficiency)
- High productivity by preheating
- Removing scale for the efficiency of oil cooler
- Measuring PH
- Scale removing chemicals and neutralization chemicals solid body type and separate type
Comparison of temperature and efficiency after user (Using scale-removing agent)
- It takes 40 minutes to increase the mold temperature by 18.8℃ from 30.7℃ to 49.5℃ before scaling (0.47℃/min).
- It takes 31 minutes and 2 seconds to increase the mold temperature by 22.5℃ from 27℃ to 49.5℃ after scaling (0.72℃/min).
- Even if cooling water of the same temperature is used for circulation, the difference in mold temperature of 4.5℃ between before scaling (46.5℃) and after scaling (51℃) enables the shortened cycle time.
- A mold, of which the mold temperature will not be decreased, is required elimination of scales for the first measure.
Specification
| Spec. / Model | 1 zone | 2 zone | |
|---|---|---|---|
| Operating Media | Water | ||
| Temperature Control Method | PID Type Control | ||
| Heater Capacity | kw | 5kw×1 | 5kw×2 |
| Media Pump Capacity | kw | 1.1kw×1 | 1.1kw×2 |
| Max. Ejection Flow | ℓ/min | 100/M | 100/M |
| Ejection Pressure | kg/㎠ | 1 ~ 4 | 1 ~ 4 |
| Size (W×L×H) | mm | 460×600×700 (+65) | 750×1480×800 |
| Applicable Peripheral Devices | Mold | ||
※ Specification could be changed for improvement without preliminary notice, order for products of special specifications other than the above products is also available.
Supplied Water Distributor
- Semi-permanent as it is made of stainless (SUS304)
- Easy to install & use
- Water Collecting Pipe for Supply and Distribution (Design registration no. 0285259)