The control of the high mold temperature is
playing the key roles from the improvement of the products.
The steam temperature controller can suddenly rise the mold temperature by supplying the high temperature steam, and can make the resin flow smooth. Also, it can shorten the cycle time of the product by supplying the cooling water in time. In this result, the steam temperature controller is suitable for the precise products.
Product type | ITC-4050 | |
---|---|---|
Input | Heating start-up signal | Emergency stop signal for Mold temperature sensor Mold temperature |
Sensor (K-type temperature sensor) | Fixed and Movable part (each 1ea) | |
Output | Temperature upper-limit signal (No contact point) |
a contact point |
Temperature lower-limit signal (No contact point) |
a contact point | |
Connecting Pipe | Cooling water input part | 40A (1 1/2") |
Output part | 40A (1 1/2") | |
Steam input part | 40A (1 1/2") | |
Mold input part | 40A (1 1/2") | |
Mold output part | 40A (1 1/2") | |
Air input part | 15A (1/2") | |
Input mediate material | Cooling water |
|
Steam input | from the steam boiler | |
Air | Air capacity (1 CYCLE / 1,060 CC) / air pressure (0.49~0.8 Mpa) | |
Out mediate material | Use the fixed pipe line to output the hot water with high temperature and pressure. Or, use the output pipe without pressure. |
|
Pump | Power Supply | 220V/380/440 3 circuits/4 circuits 50/60Hz (Option) |
Type | Centrifugal type | |
Capacity | 2.3 kw | |
Power connection |
220V/380/440 3 circuits 150/60Hz | |
Main-cable | 3.5mm | |
Grounding | D-type grounding |